Printing the PCB handles, one and a half hours at a time

EACH HANDLE REQUIRES ABOUT 90 MINUTES TO COMPLETE

This includes the time heating up the printer and a bit of cool down before I remove the finished part. There is a trivial amount of time to add some more glue to the bed before the next print.  Since I have completed three of a total of twelve that are required, I have about 14 hours of print time ahead. 

ADDITIONAL CONSTRAINTS ON WHEN I CAN PRINT

Since I don't want anything plugged in or working when I am out of the shop, this further constrains the printing as I can't start one if I will be leaving in less than 90 minutes. Before the end of the week, in any case, they will all be done

Comments

Post a Comment

Popular posts from this blog

Incompetent coders - the frustration of using Vivado to build FPGA designs

IDIOT SOFTWARE MUST BE RESTARTED CONSTANTLY TO SEE INPUT FILE CHANGES When I update a source file, often Vivado is somehow working from a cached copy and never notices the changes. It is highly frustrating to fix an issue, rerun a Linter or Synthesis and get the same old errors. The only solution is to shut Vivado down and restart. I remember hitting this many times in past years as I worked with the toolchain, but it has changed from sporadic to nearly constant failure to see the changed timestamp. I can't be the only person running the toolchain under Windows, yet this kind of bumbling misperformance has been a feature for years. 
Read more

Bizarre behavior detected in a Raspberry Pi Pico based design and partially understood

ORIENTATION OF THE PRODUCT CAN CAUSE THE PI TO FREEZE AT STARTUP This particular product with a Raspberry Pi Pico would not boot up when sitting flat on the table in its normal orientation, but if tilted or turned it would come right up. When I hooked up a USB serial connection to the debug header, it worked fine even flat on the table.  INVESTIGATION BY DESIGNER AS WELL AS ME I first assumed that I had introduced this problem in the product, but happened to describe it to the maker who was able to reproduce it reliably. I continued to try variations to determine whether it was pressure on a board or component that caused it. I also searched the web for any reports that might cause Pi Picos to fail to boot based on orientation, but found nothing.  The designer found signals introduced on a serial connection trace when sitting in the normal (failing) orientation but not injected when rotated or otherwise turned. Traces were routed from the UART0 on the Pico to a header, for use...
Read more

RK-05 emulator kit arriving today - basis of my new disk emulator

 ON THE DELIVERY TRUCK The kit from George Wiley is out for delivery today. All the surface mount components are already assembled thus the assembly of the kit is focused more on connecting boards and setting up the cabinet.  THINKING ABOUT TWO PASS PROJECT I will first assemble it as it was designed and make minor modifications to the code in order to use my Diablo 31 drive to archive various 2315 cartridges in my collection. The Diablo 31, like the RK-05, is derived from the IBM 2310 drive in the 1130 but has an improved but different interface to the controller.  Just as one small example, on the Diablo/RK-05 one can request the drive to move to a specific track and the drive itself manages the movement across as many tracks as are necessary. The 2310 however only moves one or two tracks relative to its current position, either forward or backwards. This is why the changes for the 2310 emulation are more substantial. I have attempted to test them completely in simulati...
Read more